

The Suorin Drop 2 pod kit is an open Mouth to Lung (MTL) pod system vape device that has a maximum 14W non-adjustable output. It is incorporating an internal 1000mAh battery. Comes with 2 different coil resistance pod cartridges, giving you two great vaping experiences!
In November 2021, Suorin officially released a new Suorin open pod system kit -- Suorin Drop 2 pod kit. The second generation of Suorin Drop starter kit.
The Suorin Drop 2 pod kit will come with the products below:
The gadget’s ease of use makes it ideal for both experienced and novice vapers. To use this vape
pod
kit, you can follow
the steps below:
1.Check all the packages to make sure all the accessories are ready and read the Suorin Drop 2 Use
manual before you use
it
2.Connect the device to a charging port using its Type-C cable to charge the battery. Following the
battery indicator
light guide, when 5 indicators LED lights light up constantly, it is fully charged.
3.Take out the empty pod from the device and take away the “Remove” Contact
4.Fill in your favorite e-liquid. Unplug the silicone plug of the pod and place a syringe or the
nozzle of the juice
bottle at the fill hole. Squeeze the syringe or juice bottle until the pod is full.
5.Let the pod stand for around 10 minutes to ensure the cotton is fully wet with juice when using a
new atomizer.
6.Attach the pod cartridge to the vape.
7.Breathe in via the mouthpiece at the upper corner to activate it
8.Enjoy your vaping journey!
Turning on the Suorin Drop 2 pod is very easy. Suorin Drop 2 does not have an ON/OFF switch. Instead, the Suorin Drop 2 is activated whenever you take a draw, which means that the device will be ready to use immediately after you insert the pod.
1.Unplug the silicone plug. Lightly snap sides, then pull off.
2.Pinch the sides of the cartridge with your fingers when filling
3.Please wait 5-8 minutes after filling the e-liquid into a new cartridge to make sure the cotton is
fully saturated
Suorin Drop 2 comes with a Type-C cable, you can charge it with this Type-C cable.
The vape device is normally to be dirty in our daily use. If you find the Suorin Drop 2 is dirty
with
dust or something,
you can use the tissue or wet wipes to clean it away. If you want to clean the Suorin Drop 2 pods,
you
can follow the
steps below:
1.To clean a Suorin Drop 2 pod, remove the pod from the device and gently brush away any debris with
a
dry toothbrush.
2.If needed, you can use a small amount of isopropyl alcohol on a cotton swab to clean the inside of
the pod.
3.Let the pod dry completely before reinserting it into the device.
Suorin Drop 2 kit comes with a pod battery body and a pod cartridge. They connect tightly by the magnetic contacts when you installed them. If you want to take apart them, you just need to hold their body and pod cartridge with your hands and simply take them apart from different sides.
There are four indicator LED lights showing the battery energy left on the device. When you set up the device or vape, the indicator light will blink to show you.
When 4 LED lights are on, it means there is 75%-full energy.
When 3 LED lights are on, it means there is 50%-75% energy.
When 2 LED lights are on, it means there is 25%-50% energy.
When 1 LED light is on and blinking red, it means there is a lower than 25%.
When the Drop 2 device’s battery cannot be charged, check that the charger cord is fully connected to the Type-C port. If yes, you can reconnect it carefully. Or not, you can try to change to another Type-C port cable to change it. If it still can't work, you can contact the Suorin team to fix it!
When 4 indicator lights blink 10 times, it means 5 seconds of Vaping time exceeded.
When 4 indicator lights blink 8 times, it means no atomizer was detected.
When 4 indicator lights blink 5 times, it means Ohms are too low.
When 4 indicator lights blink 3 times, it means the battery is low.
When 4 indicator lights blink 1 time, it will happen when you insert the cartridge successfully.
Suorin Drop 2 Pods are recommended to change/replace after filling e-liquid 5-8 times or within 7 days after e-liquid filling. If you use it as daily use, maybe it can long last about 2 weeks depending on the frequency of your vaping as well as the flavor.
Suorin Drop 2 has been designed on liquid leakage-proof. In general, you needn’t worry about the
leaking problem. But it
still has many reasons to cause it to leak including:
1.Vapers tighten the Drop 2 pod cartridge too much and damage the rubber rings that create the seal,
leading to leaks
2.The chimney on the device is the hollow tube inside the cartridge
3.Vapers constantly suck on the device, generate more heat and force more liquid through the
coil.
4.Overuse or chain puffing can lead to leaks
5.Broken seals and poor-fitting seals
There are many reasons that can cause a vape device to taste burnt.
1.Vape without filling enough e-liquid or didn't wait 5-8 minutes after first filling the Suorin
Drop 2 Pod cartridge and
the coil cotton didn't situate
2.Vaping too quickly, the Drop 2 is not able to keep up with the speed and strength of the draw on
it
3.Vaping the Wrong Kind of E-Liquid
4.The Drop 2 pod cartridge only lasts so long, and you need to replace it
If the aerosol is not emitted normally when puffing on the device:
A. Confirm that the cartridge is properly in place and tightly connected to the device.
B. Confirm that the device is under the “on” state.
C. Confirm that sufficient e-liquid remains in the cartridge. If not, refill the cartridge.
D. Confirm that adequate charge remains in the battery. If not, please charge as soon as
possible.
If the product still does not work, email our customer service center
at info@suorin.com or info@youmeit.shop for
further assistance.
Suorin official online store is youmeit.shop, you can buy all Suorin vapes and replacement pod
cartridges there!
Buy Suorin Drop
2 Buy
Suorin Drop 2 Pods